GE CVM1750SHSS Installation Instruction

C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet 
C3. Adjust Blower
C4. Mount the Oven
C5. Install Charcoal Filter (not supplied)

•  Read the instructions on the TOP CABINET 

TEMPLATE.

•  Tape it underneath the top cabinet.
•  Drill the holes, following the instructions on the TOP 

CABINET TEMPLATE.

You need to drill holes for the top support screws and  

a hole large enough for the power cord to fit through.

  Place the mounting plate against the wall and insert 

the toggle wings into the holes in the wall to mount 

the plate.

NOTE: Before tightening toggle bolts and wood screw, 

make sure the tabs on the mounting plate touch the 

bottom of the cabinet when pushed flush against the 

wall and that the plate is properly centered under the 

cabinet.

the wall.
  Tighten all bolts. Pull the plate away from the wall  

to help tighten the bolts.

Attach the plate to the wall using toggle bolts. At least 

one wood screw must be used to attach the plate to  

a wall stud.
  Remove the toggle wings from the bolts. 
  Insert the bolts into the mounting plate through  

the holes designated to go into drywall and reattach 

the toggle wings to 

3

ø

4

s onto each bolt. 

Wall

Mounting 

Plate

Spacing for 

Toggles More Than 

Wall Thickness

Bolt End

Toggle  

Bolt

Toggle Wings