Lynx L700PS Use & Care Manual

Page of 40
26   
 
|
 
 
SEDONA CARE & USE/INSTALLATION
The grill is factory 
set to use either 
propane (LP) or 
natural gas (NAT). 
It is critical that the 
gas you use match-
es that which the 
grill was set up for. 
You can verify that by checking the rating plate. 
The rating plate is located in one or more of the following 
places: 
• Attached to the underside of the drip tray 
• On the heat shield behind the front panel 
Ensure that the gas supplied meets with the minimum 
pressure requirements. Do not operate the grill on any gas 
other than that for which the grill has been set.
Fuel
WC Max Inlet
WC Min Under Full 
Load
Nat Gas
7 in
4 in
LP
14 in
11 in
Water Column Requirements 
Both the regulator and the manifold orifices have been 
tuned for the type of gas specified on the rating plate.  
All installation and all installation parts must conform 
to local codes with the National Electrical Code, ANSI 
Z223.1/NFPA 70 latest edition and the National Fuel 
Gas Code, ANSI Z223.1/NFPA 54 in the U.S and CGA-
B149.1/.2 in Canada.
Canadian installations must conform to CGA-B149.1/.2 
natural gas/propane installation code. (Canada) 
NATURAL GAS
It is recommended that only qualified professionals per-
form the required plumbing on this product.
To ensure satisfactory performance, the gas supply line 
GAS CONNECTIONS
BOTTLED LP HOOK-UP
2 Typical LP Bottle  
Installations
NATURAL GAS HOOK-UP
3 Typical Natural Gas 
Installations
Never connect a gas line directly to the grill. A 
pressure regulator must be installed on all gas 
equipment. All local codes require it and Lynx supplies 
the correct regulator with your grill. Removing or 
failing to install the pressure regulator can result 
in fire and serious personal injury and will void the 
warranty.
WARNING
The Rating plate lists serial numbers, model numbers 
and gas type. This one is underneath the drip tray.