Whirlpool CAE2743BQ Installation Instruction

1.  Move the washer to its final location. Place a level on top 

edges of washer. Use side seam as a guide to check levelness 

of sides. Check levelness of front using lid, as shown. Rock 

washer back and forth to make sure all four feet make solid 

contact with floor. 

IMPORTANT: Level washer properly to reduce excess noise  

and vibration.

Not Level

LEVEL

Not Level

2. On models with metal feet, use a 9/16" or 14 mm open-end or 

adjustable wrench to turn jam nuts clockwise on feet until they 

are about 1/2" (13 mm) from the washer cabinet. Then turn the 

leveling foot clockwise to lower the washer or counterclockwise 

to raise the washer.

  On models with plastic feet, use adjustable pliers to turn the 

plastic leveling foot counterclockwise to lower the washer or 

clockwise to raise the washer. On all models, recheck levelness 

of washer and repeat as needed. 

Place level here

Place level here

Jam nut

Jam nut

3.  On models with metal feet, when washer is level, use a  

9/16" or 14 mm open-end or adjustable wrench to turn jam 

nuts counterclockwise on leveling feet tightly against washer 

cabinet. 

The coin slide mechanism, service door lock and key, and coin 

box lock and key are not included with some models, but can  

be obtained from the usual industry sources.
Remove the service door of the meter case by lifting it up 

at the back. Install the money-accepting device. (Refer to 

manufacturer’s instructions for proper installation.)

HELPFUL TIP: You may want to prop up front of washer about  

4" (102 mm) with a wood block or similar object that will support 

weight of washer.

For washer using coin slides, use the adapter kit supplied with 

the washer.
Install a lock and cam on the meter case service door. Install the 

coin vault with lock and key in the meter case opening.