GE CSB9120SJSS Installation Instruction

This product requires a 120-volt, 60 Hz, 15-amp 

circuit and draws 1.8 kilowatts. This product must be 

connected to a supply circuit of the proper voltage 

and frequency. 
• Wire size must conform to the requirements of the 

National Electrical Code or the prevailing local code 

for this kilowatt rating.

• The power supply cord and plug should be brought 

to a separate 15 or 20 ampere branch circuit single 

grounded receptacle. The outlet box should be 

located within reach of the 48” power cord.

This appliance must be grounded.  In the event of 

an electrical short circuit, grounding reduces the 

risk of electric shock by providing an escape wire 

for electric current.  This appliance is equipped with 

a cord having a grounding wire with a grounding 

plug.  The plug must be plugged into an outlet that is 

properly installed and grounded.

The power cord of this appliance is equipped with 

a three-prong (grounding) plug that mates with a 

standard three-prong grounding wall receptacle to 

minimize the possibility of electric shock. Consult a 

qualified electrician or serviceman if the grounding 

instructions are not completely understood, or if 

doubt exists as to whether the appliance is properly 

grounded.

• Where a standard two-prong wall receptacle is 

encountered, it is the personal responsibility and 

obligation of the consumer to have it replaced with a 

properly grounded three-prong wall receptacle. 

Do not, under any circumstances, cut or remove the 

third (ground) prong from the power cord.
DO NOT USE AN EXTENSION CORD.  If the power 

supply cord is too short, have a qualified electrician or 

serviceman install an outlet near the appliance.

Install a recessed electrical outlet in the back wall 
of the opening within 6s of either side and at least 

9s above the cutout floor.

Locate outlet box in the shaded area

6”

9”