Whirlpool WOC54EC7A Quick Setup Guide

1. Decide on the final location for the oven. Locate existing 

wiring to avoid drilling into or severing wiring during 
installation. 

2. To avoid floor damage, set the oven onto cardboard prior to 

installation. Do not use handle or any portion of the front 
frame for lifting.

3. Remove the shipping materials and tape from the oven.

4. Remove the hardware package from inside the bag 

containing literature.

5. Remove and set aside racks and other parts from inside the 

oven.

6. Move oven and cardboard close to the oven’s final location.

IMPORTANT: Use both hands to remove oven door(s).

1. Open the oven door.

2. Locate the oven door latches in both corners of the oven 

door, and rotate the latches forward to the unlocked position.

3. Grasp the edges of the oven door with both hands and close 

the oven door until it will no longer close. Lift and pull oven 
door toward you and remove. Set the oven door aside on a 
covered work surface. 

IMPORTANT: For model KEHU309B, you must use 6 gauge 
copper or 4 gauge aluminum wire. 

This oven is manufactured with a neutral (white) power supply 
wire and a cabinet-connected green (or bare) ground wire twisted 
together.

1. Disconnect power.

2. Feed the flexible conduit from the oven through the opening 

in the cabinet. 

3. Remove junction box cover, if it is present.

4. Install a UL listed or CSA approved conduit connector to the 

junction box.

5. Route the flexible conduit from the oven to the junction box 

through a UL listed or CSA approved conduit connector.

6. Tighten screws on conduit connector.

7. See “Electrical Connection Options Chart” to complete 

installation for your type of electrical connection.

A

B

A