Lynx L27PSFR3 Owner's Manual

22

 

► location

first determine if the problem 

is being caused by location. 

if the grill is subject to high 

winds, reposition it to provide 

some protection. 

 

► checK the flame

check the gas supply and 

flame characteristics. 

(see 

indeX: “flame, correct size”)

 

 

► BuRneRs seated

check to ensure that the 

burners are correctly posi-

tioned in the grill. 

(see indeX: 

“Burner placement” for further 

details.)

 

correctly-installed burners 

should be seated firmly and 

level with no side-to-side 

movement. 

the valves on the grill feature 

an adjustable low setting. 
fluctuations in gas pressure, 

gas conversion and even in 

the quality of the gas itself 

may affect burner perfor-

mance at the “low” setting.  

it could be either too high or 

too low.  

(see indeX: “Burner 

adjustment” for further details.)

follow the same procedure as 

described for the grill burners 

to diagnose problems with the 

rotisserie burner. 
Be caReful! the rotisserie  

burner flame may be hard to 

see in bright sunny conditions.

 

► checK  

theRmocouple

the control knob must be 

held in for 30 to 60 seconds 

after ignition for the rotis-

serie burner to stay lit. 

(see 

indeX: “lighting the rotisserie” 

for further details.)

if the burner will not stay lit 

when you release the control 

knob, re-light it and hold the 

control knob in for at least 

60 seconds to allow the ther-

mocouple to heat up.  
if, after holding the control 

knob in for at least 60 

seconds, the burner still will 

not stay lit when releasing 

the control knob, call for 

service. 

(see indeX: “obtaining service 

from lynx” for further details.)

 

 

► checK poweR

ensure that the grill is 

connected to a live ac 

power source and check for 

rotisserie motor operation. 

 

► Reset tRansfoRmeR

disconnect power from the 

grill and wait 5 minutes for 

the transformer to cool down 

and reset.  then reconnect 

power.  if, after resetting the 

transformer and replacing 

bulbs, you still do not have 

power, call for service.

 

► Replace the BulB

Replacement bulbs are 

halogen, 12 volt, 10w 

max, t3 type with a 

g4 bi-pin base.  

the glass cover is held in 

place by two spring tension 

tabs. you may have to loosen 

the screw to remove the lens.
avoid touching the glass of a 

new bulb. halogen bulbs are 

very sensitive to the oils found 

in human skin.  touching the 

bulbs may shorten their life.  

pull the bulb straight out from 

the socket without twisting. 
the 27” and 30”grills each 

have one halogen light fixture; 

all other grills have two light 

fixtures. 
hold the bulb using a paper 

towel or other cloth and 

gently press it straight into the 

socket. the glass cover should 

be gently snapped back into 

place.