Thermador VTR1330P Installation Instruction

English 1

READ AND SAVE THESE INSTRUCTIONS

IMPORTANT: Save these Instructions for the Local Gas 
Inspector’s use.

INSTALLER: Please leave these Installation Instructions 
with this unit for the owner.

OWNER: Please retain these instructions for future 
reference.This appliance conforms to the relevant safety 
regulations.

Repairs should only be carried out by qualified specialists.

Check if this blower is recommended by the manufacturer 
to be installed with the hood.

Grounding instructions

This appliance must be grounded. In the event of an 
electrical short-circuit, grounding reduces the risk of electric 
shock by providing an escape wire for the electric current. 

None of the packing materials cause pollution to the 
environment and all can be recycled for use again. Please 
help to protect the environment and dispose of the 
packaging in an environment-friendly manner.

Remove all tape and packaging before using the appliance. 
Destroy or recycle the packaging after unpacking the 
appliance. 

Never allow children to play with packaging material. 

To avoid electrical shock hazard, before installing, 
switch power off at the service panel and lock the panel 
to prevent the power from being switched on 
accidentally.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, 
OR INJURY TO PERSONS, OBSERVE THE 
FOLLOWING:
a) Installation work and electrical wiring must be done 

by qualified person(s) in accordance with all 
applicable codes and regulations, including fire-
related construction.

b) Sufficient air is needed for proper combustion and 

exhausting of gases through the flue (chimney) of 
fuel burning equipment to prevent back drafting. 
Follow the heating equipment manufacturers 
guideline and safety standards such as those 
published by the National Fire Protection 

Association (NFPA), and the American Society for 

Heating, Refrigeration and Air Conditioning 
Engineers (ASHRAE), and the local code 
authorities.

c) When cutting or drilling into wall or ceiling, do not 

damage electrical wiring and other hidden utilities.

d) To properly exhaust air, be sure to duct air outside. 

DO NOT vent exhaust air into spaces within walls, 
ceilings, attics, crawl spaces, or garages.

FOR GENERAL VENTILATING USE ONLY. DO NOT 
use to exhaust hazardous or explosive materials and 
vapors.

To reduce the risk of fire or electric shock, do not use 
this blower with any solid-state speed control device.

State of California Proposition 65 Warnings:
This product contains chemicals known to the State of 
California to cause cancer, birth defects or other 
reproductive harm.

To reduce the risk of fire, use only metal ductwork.

Improper grounding can result in a risk of electric shock. 
Consult a qualified electrician if the grounding 
instructions are not completely understood, or if doubt as 
to whether the appliance is properly grounded.