Bertazzoni MASCS30X Instruction Manual
8
EN
Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock, the water
hardness parameter and the Calibration is set.
hardness parameter and the Calibration is set.
To set the clock and the water hardness
parameter value proceed as described in the
following chapters:
parameter value proceed as described in the
following chapters:
Setting the clock
Before using the oven, adjust the clock through the procedure described below but starting on Step 3.
To set the clock, proceed as follows:
To set the clock, proceed as follows:
1.
Press the “+” key until the Clock Indicator
Light starts to flash.
Light starts to flash.
2. Press the OK key.
3. Turn the
“+”/ “-“ Selector Knob to the left
or right to set the correct hour value.
4. Press the OK key to validate the hour value.
The minute numbers will start to flash.
5. Turn the
“+”/ “-“ Selector Knob to the left
or right to set the correct minute value.
6. To finish, press the OK key again.
Water Hardness setting
The system can be optimised for households with very soft water (also through using a water softening
appliance) and very hard water, by changing the user settings to the relevant range of water hardness
(see table below). To set the water hardness parameter, proceed as follows:
appliance) and very hard water, by changing the user settings to the relevant range of water hardness
(see table below). To set the water hardness parameter, proceed as follows:
(The appliance features a system that automatically indicates when it is time to descale, showing the
message “”.)
message “”.)
1. Rotate the Function Selector knob to the
position
corresponding
to
the
Water
Hardness Setting / Descaling function (not
necessary after connecting the device to the
network, or after a power failure).The water
hardness indicator light begins to flash.
necessary after connecting the device to the
network, or after a power failure).The water
hardness indicator light begins to flash.
2. Turn the
“+” / “-“ Selector Knob to set the
correct water hardness parameter value,
according to the below table.
according to the below table.
3. Press the OK key to set the parameter (or
wait until the parameter is set by time-out).
The clock is displayed.
The clock is displayed.