Whirlpool CSP2861TQ Installation Instruction

9.  Attach door hinges to dryer door so that larger hole is  

at the bottom of the hinge and the hinge pin is toward  

the door front.

10.  Remove the 4 screws that attach 2 plugs on the left side. 

Attach plugs to right side using the same 4 screws.

11.  Insert screws into bottom holes on left side of cabinet. 

Tighten screws halfway. Position door so large end of door 

hinge slot is over screws. Slide door up so screws are in 

bottom of slots. Tighten screws. Insert and tighten top 

screws in hinges.

12.  Close door and check that door strike aligns with door 

catch. If needed, slide door catch left or right within slot  

to adjust alignment.

You can change your door swing from a right-side opening to 

left-side opening, if desired.

1.   Place a towel or soft cloth on top of work space to avoid 

scratching of the surface.

2.  Open dryer door. Remove button screws from cabinet side 

of hinges. Loosen (do not remove) top screws from cabinet 

side of hinges.

3.  Lift door until top screws in cabinet are in large part of  

hinge slot. Pull forward off screws. Set door (handle side up) 

on top of towel. Remove top screws from cabinet.

4.   Remove screws attaching hinges to door.
5.  Remove screws at top, bottom, and side of door (5 screws). 

6.  Holding door over towel, grasp sides of outer door and 

gently lift to separate it from inner door. Do not use a putty 

knife to pry apart. Do not pull on door seal or plastic door 

catch.

7.  Be certain to keep cardboard spacer centered between 

doors. Reattach outer door panel to inner door panel so 

handle is on the side where hinges were just removed.

8.  Reattach screws at top, bottom, and side of door (5 screws).