Bose® WAVEMSIVPS Owner's Manual

Setting Up the System

•  To enjoy maximum audio performance:

 

—  Place the system across the room from where you listen.

 

—  Place the system within two feet of a wall, and avoid placing 

directly in a corner.

•  Place the system on a flat, stable surface.
CAUTIONS:
•  Do not place the system on a metal surface. It could interfere 

with AM reception.

•  Do not place the system on a heat-sensitive surface. Like all 

electrical equipment, it generates some heat.

•  Do not use the system in a damp location or any other place 

where moisture can get inside.

1.  Insert the small end of the power cord into the  

AC POWER connector.

2.  Plug the power cord into an AC (mains) power outlet.

After plugging in the system, set the clock using the remote. 
1.  Press and hold either Time – or Time + for about one second.

Note:   Press-and-hold operations require holding the button 

down for about one second.

Initially, 

HOLD TO SET appears on the display and then 

quickly changes to 

– CLOCK SET – as the button is  

depressed.

2.  Release the selected Time button.
3.  Press Time – to adjust the displayed time backward or press 

Time + to adjust the displayed time forward until it matches 

the current time. You can also press and hold for rapid  

adjustment.

4.  Wait five seconds for the system to exit clock setup mode.
Notes:
•  To change the clock from 12-hour (AM/PM) time to 24-hour time, 

see “Changing a system setting” on page 14.

•  If the system loses power due to a power outage or if you  

unplug the system, all system settings are permanently retained. 

However, the clock time is only temporarily stored in backup 

memory for up to 48 hours.