Electrolux E30WV60PPS Owner's Manual

List of materials- Electrical & Installation

requirements

 

List of Materials

 

 

Remove carton carefully. Wear gloves to protect 
against sharp edges. 
 

 

Hood canopy assembly with blower.

 

Lamp already installed.

 

Transition (3

1

⁄

4

” x 10” rectangular)

 

Grease filter.

 

Hardware bag with:

 

• Use and Care / Installation Manual

 

• 3- 4x8 screws (to assemble Transition)

 

• 6- 4,5x13 screws

 

• 4- 10x50 screws

 

• Torx 20 Adapter

Remove the protective film covering the product be-
fore putting into operation.

 

Wire nuts

 

Metal duct length to suit installation

 

 

1

⁄

2

”

  

Romex wire connector

 

Measuring tape

 

Pliers

 

Gloves

 

Knife

 

Safety glasses

 

Electric drill with 

5

⁄

16

” and 

3

⁄

8

” Bits

 

Spirit level

 

Duct tape

 

Screwdrivers:

 

• Phillips (Posidrive) #2

 

• Torx # 2

 

Wire cutter/stripper

 

Masking tape

 

Hammer

 

Saw, jigsaw or reciprocating saw

 

Electrical Requirements

 

 
Observe all governing codes and ordinances.
Ensure that the electrical installation is adequate and 
in conformance with National Electrical Code, ANSI/
NFPA 70 (latest edition), or CSA Standards C22.1-
94, Canadian Electrical Code, Part 1 and C22.2 No. 
0-M91 (latest edition) and all local codes and ordi-
nances.
If codes permit and a separate ground wire is used, it 
is recommended that a qualified electrician determine 
that the ground path is adequate.
A copy of the above code standards can be obtained 
from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

 

A 120 volt, 60 Hz., AC only, 15-amp, fused  

 

electrical circuit is required.

 

If the house has aluminum wiring, follow the  

 

procedure below:
1.  Connect a section of solid copper wire to the  
 

pigtail leads.

2.  Connect the aluminum wiring to the added 
 

section of copper wire using special co 

 

 

nectors and/or tools designed and UL listed 

 

for joining copper to aluminum.

Follow the electrical connector manufacturer’s recom-
mended procedure. Aluminum/copper connection 
must conform with local codes and industry accepted 
wiring practices.

 

Wire sizes and connections must conform with 

 

the rating of the appliance as specified on the 

 

model/serial rating plate. 

 

The model/serial plate is located behind the filter 

 

on the top wall by the electrical box.

 

Wire sizes must conform to the requirements of 

 

the National Electrical Code, ANSI/NFPA 70 (la 

 

est edition), or CSA Standards C22. 1-94,  

 

Canadian Electrical Code, Part 1 and C22.2  

 

No. 0-M91 (latest edition) and all local codes and 

 ordinances.