Philips DVT3000/00 User Manual

54

Service

Tip

•  Press the j key to cancel the operation without saving and return 

to the stop mode.

Caution

•  Do not remove batteries or rechargeable batteries from the 

device while it is recording. If you do this, data may be damaged or 
lost. Device malfunctions may also occur.

When the batteries are nearly empty, the battery indicator blinks; 
you should replace them. The number of the rechargeable power 
pack charge cycles is also limited. If the rechargeable batteries do not 
provide any power after a complete charging cycle via the computer, 
they must be replaced.
Proceed as described in 

Note

•  If it takes longer than 2 minutes to replace the batteries, you may 

have to reset the time.

•  Never try to recharge alkaline or non-rechargeable batteries.
•  Batteries and rechargeable batteries contain substances that 

may pollute the environment. Used batteries and rechargeable 
batteries should be disposed of at an official collection point.

Note

•  Follow the instructions on handling the device, especially the 

batteries shown in 

. Only use 

CR2025 type batteries for the remote control.

1 

Remove the battery cover from the remote control by opening 
the latch of the battery compartment on the back of the remote 
control and take out the battery compartment.