Middleby Marshall PS528E User Manual

SECTION 4

MAINTENANCE

H. Attaching Drive Chain
1. If drive sprocket assembly was removed reassemble

it into the conveyor drive shaft. Be sure flat on end of

drive shaft aligns with set screw in conveyor shaft collar.

Once in place tighten 3/32″ set screw.
2. Lift conveyor and install drive chain to conveyor drive

sprocket and motor sprocket.

Figure 4-32.

3. The angle plate located on the underside of the con-

veyor must be against the lower end plug. This is true

on both sides of oven.

Figure 4-33.

6. Reconnect the inside master links (Figure 4-29.)

Figure 4-29.

NOTE: The outside master links have right and left sides

to them. The right edge master link has an open hook

facing you as shown in Figure 4-30. This will match up

with the outer edges of the conveyor belt. Remember

this hook travels backwards on the conveyor.

Figure 4-30.

7. Reconnect the outside master links.
8. Replace all parts removed from the oven.

Figure 4-31.

Direction of travel

Crumb Pan

Mounting

Bracket

Lower End Plug