Smeg SA301W-5 User Manual

Page of 28
Instructions for the user 
 
 
 
8.2.2
 
With pins 
 
Open the door completely and insert the pins (supplied) into the holes 
from the inside. Close the door to an angle of about 45° and lift it off. To 
reassemble, fit the hinges into their grooves, then lower the door into 
place and extract the pins. 
 
 
 
8.3 
Removing the door glazing 
 
They should always be kept thoroughly clean. For easier cleaning, the 
door glazing can be fully removed by proceeding as described below. 
After opening the door and locking it in place as described in point “8.2 
Removing the door”, remove the two panes of glass. They are all 
removed in two stages: first extract the pane from the guide "A" (see 
detail) by sliding it towards you and lifting it slightly, then also free it from 
the guide "B". If the door should close during these operations, simply 
relock one of the hinges as described in point “8.2 Removing the door”. 
The panes of glass can now be washed separately. 
 
        
 
 
Use absorbent kitchen roll; remove stubborn dirt with a damp sponge 
and ordinary detergent.
 
 
Warning: before removing the panes of glass, make sure that the door 
has been locked in open position as described in point 8.2 Removing 
door. This operation might have to be repeated during the removal 
process if the door is accidentally freed. 
 
After cleaning reassemble the internal glasses following the given inctructions in 
reverse order. 
DANGER: do not use the product without glasses: the door surface will overheat 
29