APC 9000 User Manual

34006452EN/AC

 - Page 56 

"Monitor" alphanumeric display

9.10 Inverter On/Off commands  

These commands may be accessed only via the master display. When the "I/O" button is pressed,  the series of screens in 
the figure opposite is displayed.

– these commands do not concern the Static Switch Cubicle. The "I/O" button on the "static switch" cubicle produces the 
message:

– the "I/O" button on a slave display monitor produces the message:

– if the On/Off commands have not been validated (by the after-sales support technicians), pressing the "I/O" button 
produces the message:

– if a "Soft Tunor" session is in progress (initiated by after-sales support technicians), pressing the "I/O" button produces the 

message:

 

Direct access to the function by pressing the "I/O" button .

This screen is displayed if the inverter is already off. 
It is a prompt to press the "*" button to confirm start-up. 
During start-up, the following screen is displayed:

 PROCESSING
 ...

This screen is displayed if the inverter is on. It is a prompt to press 

the "*" button to confirm shutdown.

If the transfer to Mains 2 conditions are not correct, the following 
screen is displayed a few seconds: 

 COMMAND REFUSED
 TRANSFER IMPOSSIBLE

Following confirmation of the command, the system automatically 
returns to the initial screen.

COMMAND INVALID

STATIC SWITCH MODUL

COMMAND INVALID

ON SLAVE DISPLAY

COMMAND INVALID

CONFIGURATION

COMMAND INVALID

SOFT TUNOR

START  INVERTER ?

 =YES    >=ESCAPE

or

initial screen

initial screen

STOP  INVERTER ?

 =YES    >=ESCAPE