APC H10 User Manual
- 12 -
Set Up the H10
Using the front panel Dimmer and SEQ/AVR push buttons (
Using the front panel Dimmer and SEQ/AVR push buttons (
and
,
Figure 2) you can configure the following functions:
•
•
Dimmer Function — The Dimmer function allows you to set the front
panel LEDs to any of 6 brightness levels. Simply press the push button
until the desired setting is achieved.
panel LEDs to any of 6 brightness levels. Simply press the push button
until the desired setting is achieved.
•
AVR range Function — For information about how to set the AVR
range function, see
range function, see
“SEQ/AVR Push Button” under the section on
“Front Panel Controls and Indicators”
•
Delay Time Function — Once the AVR range is set, repeatedly press
the Setup push button to advance to the Delay Time Function (Figure
6) for the delayed outlets. Use the Select then Setup push button to
select within a range from 0 to 12 seconds.
the Setup push button to advance to the Delay Time Function (Figure
6) for the delayed outlets. Use the Select then Setup push button to
select within a range from 0 to 12 seconds.
8
11
8