Addonics Technologies ADI2S3GPX1-2E User Manual
Addonics
T E C H N O L O G I E S
SATA/IDE RAID PCI-E Controller
Model: ADI2S3GPX1-2E
User’s Guide
Version 1.0
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a diff erent power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a diff erent power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Overview
Note: The IDE devices attach to the IDE channel must be set as a master and
slave pair.
Note: There are four SATA ports in
SATA/IDE RAID PCI-E controller card
.
These ports are named CON1 to CON4. Ports CON3 & CON4 are
eSATA ports and CON1 & CON2 are internal SATA ports. Changing the
jumper setting on the
eSATA ports and CON1 & CON2 are internal SATA ports. Changing the
jumper setting on the
SATA/IDE RAID PCI-E Controller
card allows
you to select between eSATA and internal SATA ports. By default, ports
CON1 & CON2 are enabled.
CON1 & CON2 are enabled.
IDE Channel
eSATA
Ports
Ports
Internal
SATA ports
SATA ports
CON1
Jumper Pins
CON2
CON4
CON3