Addonics Technologies ADI2S3GPX1-2E User Manual

Delete RAID Disk Drive 
1.  Press Ctrl+J when prompted to enter the RAID BIOS. 
2.  At the next screen select Delete RAID Disk Drive, press Enter. 
3.  Use arrow keys 

• and •to select the array you want to delete, use the 

“space” key to mark the selected array, then press DEL. 

4.  When asked ALL DATA ON THE RAID WILL LOST!! ARE YOU SURE TO 

DELETE (Y/N), press Y to accept. 

 
 
Solve Mirror Conflict 
When a RAID set is created, metadata which includes drive connection 
information is written to the disk. If after a disk failure, the drive that failed was 
replaced by a disk that was previously part of a RAID set (or used in another 
system), it may have conflicting metadata. This will prohibit the RAID set from 
being either created or rebuilt. In order for the RAID set to function properly, this 
old metadata must be first overwritten with new metadata. To resolve this, from 
the main RAID BIOS window select Solve Mirror Conflict, then press Enter, the 
correct metadata, including the correct drive connection information, will be 
written to the replacement disk. 
 
 
Rebuild Mirror Drive 
If a failure on one member occurs, you will be notified by the 
RAID BIOS during boot. The steps below will guide you in rebuilding 
a failed mirror set. 
1.  Replace the failed drive with one of equal or greater capacity, then start the 

computer. 

2.  During boot press Ctrl+J to enter the RAID BIOS. 
3.  Select Rebuild Mirror Drive press Enter. 
4.  Use arrow keys 

• and •to select the array you want to rebuild, press 

Enter. 

5.  Use arrow keys 

• and •to select the destination disk, press Enter. 

6.  When rebuilding is finished, select Save And Exit Setup, press Enter. 

When asked Save to disk &Exit (Y/N)?, press Y to exit the BIOS. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
1. JMB36X RAID Configurer installation 
Note:  

To create raid volumes and monitor the status of your raid set, you need 
to install the JMB36X RAID Configurer. Install the utility from  the CD 
that came with your package. 

 

a.  Turn computer ON.  Insert Host Controller Driver Disk into CDROM. 
b.  The Addonics Technologies Driver Disk window pops up. 
c. 

Select Other Controllers. Click the ADI2S3GPX1-2E. Extract the files 
into your system. 

d.  Install JMB36X RAID Configurer by clicking the Setup.exe.  Follow the 

instructions. 

e.  After software installation, reboot the system. 

 
2.  To open the JMB36X RAID Configurer, click on the system tray the JMicron 

Icon. 

 

 

3.  This will open up the JMB36X RAID Configurer. 
 
 
 
 

 

Create 
RAID 

Create 
RAID from 
Existing Disk 

Show Disk 

Rebuild 
RAID 

Remove 
RAID