Whirlpool ELECTRONIC ELECTRIC DRYER User Manual

■

Check to see that coverings are securely stitched.

■

Shake and fluff pillows by hand periodically during the cycle.

■

Dry item completely. Foam rubber pillows are slow to dry.

NOTE: Automatic Cycles are not available when using the Air 
Only setting.

The End of Cycle Signal produces an audible sound when the 
drying cycle is finished. Promptly removing clothes at the end of 
the cycle reduces wrinkling.

Press and release the END OF CYCLE SIGNAL to adjust the 
sound level or turn off the signal.

NOTE: When the WRINKLE SHIELD™ feature is selected and the 
End of Cycle Signal is on, an audible sound will emit every 
5 minutes until the clothes are removed, or the WRINKLE 
SHIELD™ feature is finished.

The drying rack is useful for drying items you would not 
necessarily want to tumble dry or that you would normally line dry 
(for example, sweaters).

Do not remove the lint screen.

1. Open dryer door.

2. Place drying rack inside dryer drum, positioning the back wire 

on the ledge of the inner dryer back panel. Push down on 
front edge of drying rack to secure over the lint screen.

3. Put the wet items on top of the rack. Leave space between 

the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the rack. 

4. Close the door.

5. Select a timed drying cycle and temperature, or an air cycle 

(see following chart). Items containing foam, rubber, or plastic 
must be dried on a clothesline or by using the Air Only 
temperature setting.

6. You must select a time by pressing MORE TIME or LESS 

TIME. Reset time as needed to complete drying. Refer to the 
following table.

7. Press (and hold) HOLD TO START button (about 1 second).

NOTE: You must remove rack for normal tumbling. Do not use 
automatic cycles with the drying rack.

This chart shows examples of items that can be rack dried and 
the suggested cycle, temperature setting and drying time. Actual 
drying time will depend on the amount of moisture items hold.

*(Minutes) Reset time to complete drying, if needed.