Firstech, LLC. CM1000A User Manual

 

 

- 28 - 

 

CONNECTOR 1 

 
Pin 1 Brown- Siren 12-volt (+) positive output. This wire will provide a 30 or 60 second 

(+) positive output for the external siren. (Note: Factory default is 30 seconds.) 

 
Pin 2 Green/White- Parking light (+) positive output. Connect this wire to the (+) 

positive parking light wire generally at the parking light switch or behind the fuse 
box. The proper wire will test 12-volts (+) positive when the parking light switch is 
in the on position. 

 
Pin 1 Red- Constant 12-volt (+) positive power input for the control module. This wire 

must be connected to a constant 12-volt (+) positive source. The proper wire will 
test 12-volt (+) positive with the key in the off position, while key is in the on 
position and during crank. 

 
Pin 4 Black- Ground (-) negative input. This wire will connect to chassis ground. 
 
 

CONNECTOR 2 

 
Pin 1 Green/White- Parking light 250mA (-) negative output. This is an optional output 

that will provide a (-) negative output with parking light flash. 

 
Pin 2 White- Horn honk 250mA (-) negative output. This is an optional output that will 

provide a 30 or 60 second (-) negative pulse when the alarm is triggered or during 
panic. 

    
Pin 3 Yellow- Aux 1- 250mA (-) negative output. This is an optional output that will 

provide a pulse, latch or a timed pulse output. (Note: Options programmer is 
required to program a timed pulse output.) 

 
Pin 4 Yellow/White- Aux 2- 250mA (-) negative output. This is an optional output that 

will provide a pulse, latch or a timed pulse output. (Note: Options programmer is 
required to program a timed pulse output.) 

 
Pin 5 Violet- 250mA (-) negative output when armed. This wire will provide a (-) 

negative output when system is locked and armed. (Note: This wire can also be 
used to trigger after-market L.E.D. kits and other after-market accessories. Output 
must be diode isolated when used to trigger after-market accessories.)