Clover Electronics LCD2088 User Manual

Page of 176
5. Installation
 
 
25
 
5-4. Installation   
 
5-4.1. Camera Connection   
  Connection of 6pin MINI DIN Cameras 
Connect the supplied cameras to the Camera Input (6pin mini DIN jack) on the left side of the 
system as shown in [Fig. 5-2 Rear & Side View].
 
Connect the BNC cameras (not included) to the Camera Input (BNC connector) on the left 
side of the system as shown in [Fig. 5-2 Rear & Side View]
5-4.2. Installation of the Monitor 
 
 
 
 
 
 
 
 
 
 
 
 
 Desktop 
 
- Place the system on the flat surface. 
 
 - 
Do not place this product near a bathtub, kitchen sink, wet basement, over a radiator, or heat 
generator. 
   
 
  Installation of the system on the wall 
 
- Place the system on the flat surface with soft fabric as shown in Error! Reference source 
not found.].
 
 - 
Separate the  mounting bracket by removing three screws on the rear of the system as 
shown in Error! Reference source not found.] 
- The wall mounting bracket is not included in the system and refer to the manufacturer’s 
instructions on how to install it to the wall.   
 
[Fig. 5-4 Removing three screws] 
[Fig. 5-5 Separating the mounting
 
bracket