Lucent Technologies 555-661-150 User Manual

Page of 360
MERLIN LEGEND Communications System Release 6.1
Network Reference  
555-661-150  
Issue 1
August 1998
Network Management 
Page 5-15
Non-Local Dial Plan Numbering 
5
Centralized Automated Attendant Programming
5
Programming for a centralized automated attendant is the same as for a local 
automated attendant with the following differences:
If incoming calls at remote systems are to be answered by the centralized 
automated attendant, establish a VMI calling group at each remote system. 
The extension for the VMI calling group at the remote systems does not 
have to be the same at all systems. Assign the lines to the VMI calling 
group and assign the extension for the centralized VMS/AA as the single 
non-local member. In this case the special routing (absorbing and 
prepending digits) is not required and a pattern used for routing other voice 
calls can be assigned to the range. The number of digits to dial must be 
assigned to the range (new programming for Release 6.0 V11 and Release 
6.1 and later systems).
SECURITY
l
ALERT:
!
Program the centralized VMS/AA to include all local and non-local covered 
extensions on any system. This is necessary for security purposes so that 
the automated attendant can be restricted to transfer only to subscribers. 
See Appendix C for more information.
All trunks within the private network should have unique trunk numbers. 
This allows the centralized automated attendant (such as Intuity) to deliver 
unique greetings based on the trunk on which the call was received.
Non-Local Dial Plan Numbering
5
As part of implementing a private network, the system manager at each private 
networked system specifies ranges of extensions for non-local systems 
connected directly or via another private network system to the local MERLIN 
LEGEND Communications System. The process does not affect programming on 
non-local systems but allows smooth communications among private networked 
systems. 
This topic describes the following two management tasks:
Specifying new extension number ranges
Deleting extension number ranges 
The extension ranges you enter using this procedure include the numbers that 
users on your system dial in order to make System Access (SA) calls to users on 
a non-local system. Users dial these calls in the same way that they dial inside 
calls on your local system. Numbering must be planned to avoid conflicts and 
provide unique and unambiguous extension numbers across private networks.