Sterling XXX10-80 User Manual
10-Pump, 80-Station Controller
Chapter 3: Installation
47
Finishing Setup: Setting Up Passwords
You can set up passwords for two levels of security: for operators and for setup personnel.
The controller comes from the factory with neither password set. This allows every user
access to all functions.
You can set up passwords for two levels of security: for operators and for setup personnel.
The controller comes from the factory with neither password set. This allows every user
access to all functions.
Setup Password. If you define a password for setup personnel, then most settings can be
changed only after entering the password. The password will be required to display the
following screens:
changed only after entering the password. The password will be required to display the
following screens:
• System Setup (to review and change system-wide settings and go to
the network status screens)
• Station Setup (to review and change settings for all station options)
• Pump Setup (to review and change settings for all pump options)
• Pump Setup (to review and change settings for all pump options)
Operator Password. If you define a password for operators, then a password will be
required to carry out any function (other than reviewing station and pump status, silencing
alarms, reviewing the alarm log, and looking at help screens). Entering the operator’s
password will give the user access to the functions at the following screens:
required to carry out any function (other than reviewing station and pump status, silencing
alarms, reviewing the alarm log, and looking at help screens). Entering the operator’s
password will give the user access to the functions at the following screens:
• Station Status (to enable or disable a station, and start or stop system)
• Pump Status (to enable or disable a pump, and start or stop system)
• Station n Operator (to adjust a station’s convey time and dump delay,
• Pump Status (to enable or disable a pump, and start or stop system)
• Station n Operator (to adjust a station’s convey time and dump delay,
activate priority convey, and review the station’s last convey time and
pump assignment; depending on the options installed, the screen may
also enable the operator to adjust the mixture percentage for a remote
proportioning valve, change the purge time and purge valve, and set
the intended material line for manifold sharing)
pump assignment; depending on the options installed, the screen may
also enable the operator to adjust the mixture percentage for a remote
proportioning valve, change the purge time and purge valve, and set
the intended material line for manifold sharing)
Entering the setup password will give the user access to all functions.
To set (or remove) password protections:
1. Press System Setup on the right side of the screen to go to the System Setup
screen if needed.
The System Setup screen appears:
The current passwords are displayed under Operator Password and Setup
Password
Password
. No value means that no password is required.