Lucent Technologies 4.1 User Manual

During System Programming, the normal functions of several buttons on the
display phone at extension 10 or 11 change. For example, the left [

]

button becomes [

] and the right [

] button becomes

[

]. The Programming Overlay identifies these buttons.

You use the following special buttons while programming:

■

■

■

■

■

■

■

■

■

[

] and [

] cycle forward and backward through the

programming procedures. You can use these buttons to select a
procedure.

[

] and [

] cycle forward and backward through a procedure’s

parameters. A parameter is typically an outside line, a pool, an
extension, or a telephone list entry.

[

] and [

] cycle forward and backward through the valid

entries. These buttons work only for fixed data, such as a line or
extension number. They do not work for variable data such as date, time,
password, telephone numbers, or doorphone assignments.

[

Assignment (#301), removes lines from an extension; when using Pool
Extension Assignment (#314), removes pools from an extension.

[

] ends an entry of variable length, such as a telephone number in an

Allowed Phone Number List.

[

] starts the System Programming process.

[

] starts the Centralized Telephone Programming process (to

customize individual telephones centrally from extension 10 or 11).

[

] when followed [

] [

], enters or exits programming mode.

[

] enters a “wildcard” (a character that matches any digit dialed) in

Phone Number Lists (#404), and the Forced Account Code List (#409).

When programming from a PARTNER-model phone at extension 10 or 11, keep
in mind that the button you press at the programming extension may be in a

page 2-17 shows the relative location of buttons on each PARTNER-model
phone. For example, the button labeled E on the PARTNER-34D phone in
Figure 2-4 is in the bottom row. The equivalent button on the PARTNER-18D
phone is in the leftmost position of the second row from the bottom.

If your system has a mix of PARTNER- and MLS-model phones, refer to
Appendix E for information about programming from a PARTNER-model phone
to an MLS-model phone or from an MLS-model phone to a PARTNER-model

phone.

Programming