Alliance Laundry Systems 907003062 Manual De Usuario

Installation

70420801 (EN)

Position and Level the Tumble Dryer

The tumble dryer may be moved with or without the

skid. To remove the skid, unscrew the four shipping

bolts, and discard them.
To fit a 170 pound tumble dryer (with shipping skid)

through an 8 foot (2.43 meters) high door, you must

remove the front access panel. The upper 3 inches

(76 mm) of the stove must also be removed on

170 pound gas tumble dryers. Removing the entire gas

or steam heater assembly and the shipping skid, will

reduce the height of the 120 pound tumble dryer to 70

inches (1778 mm), and the 170 pound tumble dryer to

75 inches (1905 mm).
Level the tumble dryer to within 0.125 inch (3 mm)

from front-to-rear (level on cylinder rib), and side-to-

side (level on top panel). Shim under corners to level

and stabilize unit. Tumble dryer must not rock.

Before Placing Tumble Dryer into
Service

1. Remove or open all panels and check accessible

bolts, nuts, screws, terminals and fittings for

tightness.

2. Check V-belt tension and adjust if necessary.

Refer to appropriate paragraphs in Adjustments

Section.

3. Replace all panels and guards.
4. Turn on electrical supply to tumble dryer.
5. Open supply valve for gas or steam heated

tumble dryers.

6. After performing the previous checks, start

the tumble dryer by pressing START (hold for

approximately 3 seconds). Release the start

button and open the loading door. The cylinder

should stop rotating within 7 seconds after the

door is opened.

7. Gas tumble dryers: Start the tumble dryer and

check the burner flame. Adjust the gas inlet

shutter as required. Refer to Adjustments section.

IMPORTANT: The Electronic Ignition system will

attempt to light the gas by sparking for the “trial

for ignition” period. If gas does not ignite within

this period, the ignition control will go into a safety

lockout and the valve will no longer open until the

control is reset. Refer to Table 1. It may be

necessary to restart several times to bleed air out of

gas lines. To reset, open and close loading door,

then start.

If lockout condition persists, check that the manual

gas shut-off valve is in the open position and that

the gas service is properly connected. If condition

still persists, remove tumble dryer from service.

8. Load the cylinder with a full load of clean rags

and run to remove oil or dirt from cylinder.

Location

Prepurge

Time

(seconds)

Trial for

Ignition

(seconds)

Reset

Lockout

Condition

By:

CE and

Australia

Press and

hold reset

button on

junction box

until light

goes out.

All others

1-3

Open loading

door.

Table 1