Cisco Systems 2130 Manual De Usuario

Make sure the ejector tabs at both ends of the DIMM slots are pushed outward to the sides (open 
position). (See location 1 in 

.)

Holding the DIMM by the top edges, remove it from its anti-static package.

Do not touch the DIMM connectors. Handle the DIMM only by the edges.

Position the DIMM above the slot. Align the notch on the bottom edge of the DIMM with the key in the 
DIMM slot. (See location 2 in 

.)

Insert the bottom edge of the DIMM into the slot. (See location 3 in 

When the DIMM is correctly positioned, push down firmly on the top edge of the DIMM until the ejector 
tabs snap into place. (See location 4 in 

.)

Install the appliance cover. For instructions, see the 

To remove a DIMM:

Review the information in the 

 and the 

.

Power down the appliance and all external devices. Disconnect the AC power cord or DC power source 
and all external cables.

Attach the antistatic wrist strap to your wrist and connect its cord to the ESD socket on the top, left-hand 
side on the front of the appliance.

Remove the appliance cover. For instructions, see the 

.

Locate the DIMM slots. (See 

Open the ejector tabs on the DIMM slot by pushing them out to the sides. (See location 1 in 

.)

Holding the DIMM by the edges, lift it straight up out of the slot, and store it in an antistatic package.

Install the appliance cover. For instructions, see the 

The PCI adapter cards are not hot-swappable. Before removing or replacing an adapter card, you must 
first take the Cisco ADE 2130 and 2140 Series appliance out of service, turn off the appliance by 
pressing the power button, disconnect all external cables, and unplug the AC power cord or DC power 
source from the appliance.

This section describes how to install a PCI adapter card in the Cisco ADE 2130 and 2140 appliance. 
Before you install an adapter card, review the following information: