Citizen CL-S6621 Manual De Usuario

45

Besides the Menu Setup Mode, you can also select the ribbon winding 
direction (outside-wound / inside-wound) by using the keys on the 
Operation Panel.
Outside-wound and inside-wound will switch from one to another each 
time you press the PAUSE key for 4 seconds or more while pressing the 
MODE/REPEAT key when not printing.

  If the outside-wound (also known as “ink out”) gets selected, the 

buzzer will sound 3 times, and CONDITION LED will flash.

  If the inside-wound (also known as “ink in”) gets selected, the buzzer 

will sound 4 times, and CONDITION LED will flash.

When the lights go out on the CONDITION LED, selection is finalized.
Changes will remain in effect even after the power is turned off.

Note:  The winding direction cannot be changed when printing.

A different emulation will be detected when the Emulation Auto Detect 
of the System Setup is set to On or Full Auto. (Detects Zebra® when 
Datamax® is selected, and Datamax® when Zebra® is selected.)

 If the “Emulation Auto Detect” is set to “On”
 

If the “Emulation Auto-Detect” is set to “On”, this will cause the 
CONDITION LED to flash when it detects an alternative emulation. By 
selecting MODE/REPEAT KEY, the printer will restart and emulation 
will automatically make a switch. By selecting another KEY, detection 
will be canceled, and CONDITION LED will turn Off.

 If the “Emulation Auto Detect” is set to “Full Auto”
 

If the “Emulation Auto Detect” is set to “Full Auto”, this will cause 
the printer to restart when it detects an alternative emulation, and 
emulation will automatically make a switch.

Menu Setting Table  (p.39, p.42)