SMSC LAN9420i Manual De Usuario
Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
Revision 1.22 (09-25-08)
132
SMSC LAN9420/LAN9420i
DATASHEET
4.4.11
Wakeup Frame Filter (WUFF)
This register is used to configure the Wakeup Frame Filter.
Offset:
00A8h
Size:
32 bits
BITS
DESCRIPTION
TYPE
DEFAULT
31:0
Wakeup Frame Filter (WFF)
The Wakeup Frame Filter is configured through this register using an
indexing mechanism. Following a reset, the MAC loads the first value
written to this location to the first DWORD in the Wakeup Frame Filter (filter
0 byte mask). The second value written to this location is loaded to the
second DWORD in the wakeup Frame Filter (filter 1 byte mask) and so on.
Once all eight DWORDs have been written, the internal pointer will once
again point to the first entry and the filter entries can be modified in the
same manner. Similarly, eight DWORDS should be read sequentially to
obtain the values stored in the WFF.
The Wakeup Frame Filter is configured through this register using an
indexing mechanism. Following a reset, the MAC loads the first value
written to this location to the first DWORD in the Wakeup Frame Filter (filter
0 byte mask). The second value written to this location is loaded to the
second DWORD in the wakeup Frame Filter (filter 1 byte mask) and so on.
Once all eight DWORDs have been written, the internal pointer will once
again point to the first entry and the filter entries can be modified in the
same manner. Similarly, eight DWORDS should be read sequentially to
obtain the values stored in the WFF.
Note:
This register should be read and written using eight consecutive
DWORD operations. Failure to read or write the entire contents of
the WFF may cause the internal read/write pointers to be left in a
position other than pointing to the first entry.
DWORD operations. Failure to read or write the entire contents of
the WFF may cause the internal read/write pointers to be left in a
position other than pointing to the first entry.
R/W
0000_0000h