Parker Products OEM650 Manual De Usuario
7
OEM650/OEM650X • INSTALLATION
OEM size 34 motors are internally wired in parallel. A 75VDC
power supply (OEM300) must be used to achieve maximum perfor-
mance; however, lower voltage power supplies may be used (less
than 75VDC but must be greater than 24VDC). The lower voltage
power supply will not adversely affect the system's low-speed
performance, but it will not yield the optimum high-speed perfor-
mance achieved by using the 75VDC power supply.
power supply (OEM300) must be used to achieve maximum perfor-
mance; however, lower voltage power supplies may be used (less
than 75VDC but must be greater than 24VDC). The lower voltage
power supply will not adversely affect the system's low-speed
performance, but it will not yield the optimum high-speed perfor-
mance achieved by using the 75VDC power supply.
❐
Size 34 motors are internally wired in a parallel configuration
(OEM83-62-MO, OEM83-93-MO, OEM83-135-MO)
Top View
BLACK
A-
GREEN
B-
RED
A+
WHITE
B+
OEM
s
e
r
i
e
s
REMOTE
REF
CURRENT
DUMP
VDC+
VDC-
A+
A-
B+
B-
POWER
FAULT
}
Size 34 OEM Series Motors: Parallel Wiring
Figure 2-3. NEMA 34 Size OEM Motor Wiring—Series
5. Set motor current. Table 2-7 contains the proper motor current
settings for Compumotor OEM motors. A 1/4 watt resistor
connected between
connected between
REF
and
CURRENT
sets motor current.
Adjust the drive current to match the motor that you are using.
OEM
s
e
r
i
e
s
REMOTE
REF
CURRENT
DUMP
VDC+
VDC-
A+
A-
B+
B-
POWER
FAULT
REMOTE
REF
CURRENT
DUMP
VDC+
VDC-
A+
A-
B+
B-
Motor Current
Selection Resistor
OEM650/OEM650X
Terminals
For best installation
results, be sure that the
resistor lead wire is long
enough for easy insertion
into the REF and
CURRENT terminals.
results, be sure that the
resistor lead wire is long
enough for easy insertion
into the REF and
CURRENT terminals.
Figure 2-4. Motor Current Selection Resistor