PioneerPOS G24-LC Manual De Usuario
Modem Configuration and Profile
3-192
G24-L AT Commands Reference Manual
April 15, 2008
The following table shows the Qn parameters.
Example
ATQ0
OK
ATQ?
Q: 0
OK
ATQ4
ERROR
ATQ1
//No response because result codes are suppressed.
ATQ4
//No response because result codes are suppressed.
E, Command Echo
This command defines whether input characters are echoed to output. If so, these characters are
echoed at the same rate, parity and format at which they were received.
echoed at the same rate, parity and format at which they were received.
The following table shows the E parameters.
Table 3-128: Qn Parameters
<Parameter>
Description
<value>
0
Transmit result codes.
1
Suppress result codes.
The default value is 0.
Command Type
Syntax
Response/Action
Remarks
Set
ATE<value>
OK
or:
+CME ERROR: <err>
The Set command sets whether or not
to echo characters.
to echo characters.
Read
ATE?
<current value>
The Read command reads the current
setting for command echo.
setting for command echo.
Test
The Test command for E is not defined
by ITU, and therefore is not supported
by the G24-L. The G24-L returns an
error.
by ITU, and therefore is not supported
by the G24-L. The G24-L returns an
error.
Table 3-129: En Parameters
<Parameter>
Description
<value>
0
Does not echo characters
1
Echoes characters
The default value is 0.