Cisco Systems 1000 Series Manual De Usuario
5-123
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
Upgrade Process with Service Impact for Nonredundant Platforms
DETAILED STEPS
Command or Action
Purpose
Step 1
show version
show version
installed
dir
filesystem
:
<
directory
>
show platform
show redundancy-states
Example:
Router# show version
Router# show version r0 installed
Router# dir bootflash:
Router# show platform
Router# show redundancy-states
(Optional) Use the following commands to confirm the
current router configuration, as follows:
current router configuration, as follows:
•
show version and show version active-rp
installed—Verify the running version of the Cisco IOS
XE software on the router, and which file was used to
boot the router, and where that file is stored.
installed—Verify the running version of the Cisco IOS
XE software on the router, and which file was used to
boot the router, and where that file is stored.
•
dir—Confirm that the files that were used to boot the
router are located in the directory.
router are located in the directory.
•
show platform—Confirm the current status of the
active and standby RPs.
active and standby RPs.
•
show redundancy states—Confirm the operational
and configured redundancy states.
and configured redundancy states.
Step 2
redundancy
mode sso
Example:
Router(config)# redundancy
Router(config-red)# mode sso
Configure SSO if it is not already configured.
Note
Save the configuration after making this
configuration step.
configuration step.
Step 3
mkdir
URL-to-directory-name
Example:
Router# mkdir usb0:221subs
Create a directory to store the consolidated package and
subpackages.
subpackages.
This directory must be created in most cases because the
consolidated packages and subpackages have to be
separated from the subpackages that booted the router at
this step of the procedure.
consolidated packages and subpackages have to be
separated from the subpackages that booted the router at
this step of the procedure.
Step 4
ip tftp
source-interface gigabitethernet port
Example:
Router(config)# ip tftp source-interface
gigabitethernet 0
Specifies the Gigabit Ethernet TFTP source-interface to be
configured:
configured:
slot/port—Specifies the location of the TFTP
source-interface.
source-interface.
Note
To copy a file using TFTP through the Management
Ethernet interface, the ip tftp source-interface
GigabitEthernet 0 command must be entered
before entering the copy tftp command.
Ethernet interface, the ip tftp source-interface
GigabitEthernet 0 command must be entered
before entering the copy tftp command.
Step 5
copy tftp:
URL-to-target-location
Example:
Router# copy tftp: usb0:221subs
Copy the consolidated package file into the directory
created in
created in
The consolidated package in this step should not be copied
into the same directory where the subpackages that are
currently running your router are stored (the directory
containing the packages.conf provisioning file from which
the router was booted).
into the same directory where the subpackages that are
currently running your router are stored (the directory
containing the packages.conf provisioning file from which
the router was booted).
Tip
It is recommended that you copy the package onto
a usb: or harddisk: file system for space
considerations when performing this step of the
procedure.
a usb: or harddisk: file system for space
considerations when performing this step of the
procedure.