Cisco Systems 1000 Series Manual De Usuario
16-20
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 16 Configuring MPLS Layer 2 VPNs
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
pseudowire-class atm-fr-bridged
encapsulation mpls
interworking ethernet
!
interface Loopback0
ip address 44.1.1.2 255.255.255.255
!
interface GigabitEthernet0/0/1
ip address 10.10.1.2 255.255.255.0
negotiation auto
mpls ip
!
interface ATM0/1/2
no ip address
atm clock INTERNAL
no atm enable-ilmi-trap
!
interface ATM0/1/2.1 point-to-point
mtu 1500
no atm enable-ilmi-trap
pvc 10/100 l2transport
encapsulation aal5snap
xconnect 190.1.1.1 100 pw-class atm-fr-bridged
!
!
To configure the Frame Relay-to-ATM Bridged Interworking feature on a Frame Relay PE router,
perform the following steps:
perform the following steps:
Note
The following configuration uses a channelized T1/E1 interface. Frame Relay can be configured on other
interfaces such as Packet over SONET (PoS) as well.
interfaces such as Packet over SONET (PoS) as well.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
(Optional) ipv6 unicast-routing
4.
mpls label protocol ldp
5.
mpls ip default-route
6.
mpls ldp graceful-restart
7.
frame-relay switching
8.
xconnect logging pseudowire status
9.
controller t1 slot/subslot/port
10.
framing esf
11.
clock source internal
12.
linecode b8zs
13.
cablelength long db-loss-value
14.
channel-group channel-group-number timeslots range
15.
exit