Cisco Systems 1000 Series Manual De Usuario

16-22

Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide

OL-16506-17

Chapter 16 Configuring MPLS Layer 2 VPNs

Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking

DETAILED STEPS

Command or Action

Purpose

Step 1

enable

Example:

Router> enable

Enables privileged EXEC mode.

Enter your password, if prompted.

Step 2

configure terminal

Example:

Router# configure terminal

Enters global configuration mode.

Step 3

ipv6 unicast-routing

Example:

Router# ipv6 unicast-routing

(Optional) Enables the task of forwarding the IPv6
unicast datagrams.

Step 4

mpls label protocol ldp

Example:

Router(config)# mpls label protocol ldp

Specifies the label distribution protocol (LDP) for
the Frame Relay PE router.

Step 5

mpls ip default-route

Example:

Router(config)# mpls ip default-route

Enables the distribution of labels associated with the
IP default route.

Step 6

mpls ldp graceful-restart

Example:

Router(config)# mpls ldp graceful-restart

Enables MPLS LDP graceful restart.

Step 7

frame-relay switching

Example:

Router(config)# frame-relay switching

Enables PVC switching on a Frame Relay data
circuit-terminating equipment (DCE) device.

Step 8

xconnect logging pseudowire status

Example:

Router(config)# xconnect logging pseudowire status

Enables system logging (syslog) reporting of
pseudowire status events.

Step 9

controller t1 slot/subslot/port

Example:

Router(config)# controller T1 0/3/0

Configures a T1 controller and enters the controller
configuration mode.

Step 10

framing esf

Example:

Router(config-controller)# framing esf

Selects the Extended Super Frame (ESF) for a T1
data line.