ATTO Technology 2390C/R/D Guía Del Usuario
10
Manual reset switch
A manual reset switch reboots the FibreBridge.
To reset the FibreBridge, depress the reset button for
no more than three seconds.
To restore factory defaults, press the reset button for
more than four seconds until the green Ready LED
blinks.
To reset the FibreBridge, depress the reset button for
no more than three seconds.
To restore factory defaults, press the reset button for
more than four seconds until the green Ready LED
blinks.
LED indicators
The LED indicators can be viewed from the connector
side and the front side of the FibreBridge 2400R/D.
(See Exhibit 1.4-1)
LEDs on the connector side are:
side and the front side of the FibreBridge 2400R/D.
(See Exhibit 1.4-1)
LEDs on the connector side are:
A bicolor Ready/Fault LED
lights green to indicate
ready, lights yellow to show a faulted condition, and is
off to indicate not ready.
off to indicate not ready.
Embedded in the Ethernet port connector:
a
lighted green LED shows a valid link; off indicates
that no link is present. A separate blinking yellow LED
indicates activity.
indicates activity.
Fibre Channel port:
A lighted green LED indicates
link; off means no link. A separate green LED
indicates activity if it is lit, no activity if it is off.
indicates activity if it is lit, no activity if it is off.
SCSI ports:
A green LED on each port indicates
activity if is lit.
LEDs on the faceplate are:
LEDs on the faceplate are:
A bicolor Ready/Fault LED
is lighted green to
indicate ready, lighted yellow to show a faulted
condition, and off indicates not ready.
condition, and off indicates not ready.
SCSI ports:
A green LED on each port indicates
activity if is lit.
Fibre Channel port:
bicolor LED indicates FC
speed. If it is off, speed is 1-Gb; if it is green, 2-Gb,
and yellow indicates 4-Gb FC. A separate green LED
indicates activity if it is lit, no activity if it is off.
and yellow indicates 4-Gb FC. A separate green LED
indicates activity if it is lit, no activity if it is off.
Exhibit 1.4-1 Connectors, LEDs and power receptacle
Ready/Fault LED
Ethernet port
Fibre Channel ports
SCSI ports
SCSI activity LEDs
FC activity & link LEDs
Serial port
Power receptacle
air vents
Reset switch
on the connector side and LEDs on the faceplate