Cisco Systems 11000 Series Manual De Usuario
2-27
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
Chapter 2 Cabling the CSS
Connecting Power Cords
Connecting a CSS 11050 or CSS 11150 AC Power Cord
To connect an AC power cord to a CSS 11050 or CSS 11150:
1.
Ensure that the CSS power switch is in the 0 (off) position.
2.
Attach the power cord to the CSS by plugging the AC power cord connector
into the power receptacle at the rear panel, as shown in
into the power receptacle at the rear panel, as shown in
.
Figure 2-17 Connecting a CSS 11050 or CSS 11150 AC Power Cord
3.
Plug the power cord into a dedicated 3-wire grounding receptacle.
4.
Switch on the power on the CSS.
Connecting a CSS 11150 DC Power Cord
Before you install a DC power cord, see Appendix A,
for DC
power supply safety warnings.
Warning
The DC power supply cord requires 18 AWG wire. The CSS 11150 draws a
maximum of 25 amps.
maximum of 25 amps.
Warning
DC systems do not have a power switch. A chassis configured for DC power
requires an external power disconnect device (such as an external circuit
breaker).
requires an external power disconnect device (such as an external circuit
breaker).
Power switch
AC power cord
AC -100 -240 VAC
50 - 60HZ 3.1AMax.
50 - 60HZ 3.1AMax.
49590