Cisco Systems 11000 Series Manual De Usuario
2-29
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
Chapter 2 Cabling the CSS
Connecting Power Cords
3.
Install the wires into the appropriate connector. Make sure that the
uninsulated part of each wire is 9mm (0.35 in.) in length.
uninsulated part of each wire is 9mm (0.35 in.) in length.
When installing the wires, always connect the ground wire first. When
disconnecting the wires, always disconnect the ground wire last.
disconnecting the wires, always disconnect the ground wire last.
The proper power cable wiring between the CSS 11150 and DC power source
is illustrated in
is illustrated in
.
4.
Tighten the captive screws to 5 to 7 inch-pounds (.6 to .8 Nm) of torque to
secure the wires in the connectors. Ensure the wires are held firmly in place.
secure the wires in the connectors. Ensure the wires are held firmly in place.
Connecting a CSS 11800 Power Cord
The following sections provide information for connecting an AC or DC power
cord to a CSS 11800.
cord to a CSS 11800.
Note
For information on installing a redundant AC or DC power supply, consult the
reference sheet included with the power supply.
reference sheet included with the power supply.
Table 2-10 CSS 11150 to DC Power Source Cabling
CSS 11150
DC Power Source
(Ground)
(Ground)
+
+
–
–