Lexmark 350d Manual De Usuario

If the print media is curled once it exits the printer, Reduced Curl mode can be turned on to help reduce the problem. 
However, before turning this mode on, you should try the possible solutions offered in Troubleshooting. For more 
information, see The paper is curled once it exits the printer.

Note: Print speed is significantly slower in Reduced Curl mode.

Turn the printer off.

Note: Disabling the control panel menus does not prevent access to other menu groups.

Press and hold  and  while turning the printer on.

Release both buttons when 

 appears on the display.

The printer performs its power-on sequence, and then 

 appears on the first line of the display.

Press  until 

 appears, and then press 

.

 is default. 

Press  once, 

 appears.

Incorrect characters 
print.

You are using an 
incompatible parallel 
cable.

If you are using a parallel interface, make sure you are using an 
IEEE 1284-compliant parallel cable. We recommend Lexmark part 
number 1021231 for the standard parallel port.

The printer is in Hex 
Trace mode.

If 

 appears on the display, you must exit Hex Trace 

mode before you can print your job. Turn the printer off and back on 
to exit Hex Trace mode.

Large jobs do not 
collate.

Collate is not set to 
On.

Set Collation to 

 in the Finishing Menu or through the printer 

driver.

Note: Setting Collation to 

 in the driver overrides the setting in 

the Finishing Menu.

For more information, see the Menus and Messages Guide.

The job is too 
complex.

Reduce the complexity of the print job by eliminating the number 
and size of fonts, the number and complexity of images, and the 
number of pages in the job.

The printer does not 
have enough 
memory.

Add printer memory.

Unexpected page 
breaks occur.

The job has timed 
out.

Set Print Timeout to a higher value from the Setup Menu.

For more information, see the Menus and Messages Guide.

The paper is curled 
once it exits the printer.

The print media has 
been in the printer too 
long or is too heavy.

The print job has too 
many pages for 
simplex printing.

The paper has 
absorbed moisture 
due to high humidity.

• Use paper that is sealed in its original packaging.
• Turn the paper over.
• Rotate the paper 180 degrees.
• If you are printing a multiple-page job, try duplexing it.
• When printing on heavy print media, open the rear exit door for a 

straight-through path.

• Try another kind or brand of print media, such as a xerographic 

paper for laser printers.

• If possible, try printing in a less humid environment.

If the paper still curls, select the Reduced Curl setting from the 
Configuration menu (see Turning on Reduced Curl mode).