Sony DVS-9000 Manual De Usuario
193
C:\WINNT\Profiles\Administrator\Desktop\WORK_08_21\370467401
DVS9000WW\01GB05C03-WW.fm
DVS9000WW\01GB05C03-WW.fm
masterpage:Right
Executing a Transition
Chapter 3
T
ransitions
DVS-9000/9000SF
3-704-674-01 (1)
For an overview of the auto transition, see page 33.
To carry out an instantaneous cut transition: Press the [CUT] button.
To carry out a gradual transition: Press the [AUTO TRANS] button.
To carry out a gradual transition: Press the [AUTO TRANS] button.
This executes the transition at the preset transition rate (see page 188).
While the transition is executing, the [AUTO TRANS] button lights
amber. When it completes the button goes off.
While the transition is executing, the [AUTO TRANS] button lights
amber. When it completes the button goes off.
To complete a partially executed transition instantaneously: Press the
[CUT] button.
The [AUTO TRANS] button goes off.
The [AUTO TRANS] button goes off.
Executing a Transition With the Fader Lever (Manual
Transition)
Transition)
To execute a manual transition with the transition control block fader lever, use
the following procedure.
the following procedure.
For an overview of the manual transition, see page 33.
To carry out the transition completely: Move the lever over the full range of
its travel.
To pause a partly executed transition: Stop moving the fader lever.
To resume a paused transition: Resume moving the fader lever.
To resume a paused transition: Resume moving the fader lever.
Combinations of Auto and Manual Transitions
Using the [AUTO TRANS] button, the [CUT] button, and the fader lever, use
the following procedures.
the following procedures.
Moving the fader lever during an auto transition
During an auto transition started by pressing the [AUTO TRANS] button,
operating the fader lever immediately enables the fader lever, and the [AUTO
TRANS] button goes off. Thereafter, the fader lever controls the progress of
the transition.
operating the fader lever immediately enables the fader lever, and the [AUTO
TRANS] button goes off. Thereafter, the fader lever controls the progress of
the transition.
Executing an auto transition after partly moving the fader lever
• Press the [CUT] button to instantaneously complete the transition.
• Press the [AUTO TRANS] button to complete the rest of the transition at the
• Press the [AUTO TRANS] button to complete the rest of the transition at the
preset transition rate.