KitchenAid KSSC36QMS Manual De Usuario

Descargar
Página de 76
18
INSTALLATION INSTRUCTIONS
Unpack the Refrigerator
IMPORTANT: 
Do not remove the protective film until the refrigerator is in its 
operating position.
All four leveling legs must contact the floor to support and 
stabilize the full weight of the refrigerator.
Keep the cardboard shipping piece or plywood under the 
refrigerator until it is installed in the operating position.
1. Remove and save the literature package and parts bag taped 
to the refrigerator door. Remove the four brackets (two on 
each side) that attach the shipping base to the refrigerator 
bottom. 
NOTE: Do not remove tape and door bracing until the 
refrigerator is in its final position. 
2. If necessary, reduce the tipping radius. See “Tipping Radius” 
for ceiling height requirements or “Reduce Tipping Radius” 
for step-by-step instructions.  If you do not need to reduce 
the tipping radius, proceed to “Move the Refrigerator into 
House.”
Reduce Tipping Radius
(if required)
Before bringing the refrigerator into the home, be sure there is 
adequate ceiling height to stand the refrigerator upright. See 
“Tipping Radius.”
If you do not have adequate ceiling height to stand the 
refrigerator upright, the tipping radius can be reduced by 
removing the top grille and side trims (see the following chart). 
Classic and Overlay Series
1. Grasp both ends of the top grille.
2. Push the top grille straight up, then pull straight out. Lay the 
grille on a soft surface.
3. Remove the six screws attaching each cabinet side trim to 
the refrigerator and remove the side trims.
Architect
®
 Series
1. Grasp both ends of the louver panel. Push the louver panel 
straight up, then pull straight out. Lay the panel on a soft 
surface.
2. Grasp both ends of the top grille. Push the top grille straight 
up, then pull straight out. Lay the top grille on a soft surface. 
3. Remove the six screws attaching each cabinet side trim to 
the refrigerator and remove the side trims.
Pro Line
®
 Series
1. Grasp both ends of the top grille.
2. Push the top grille straight up, and then pull straight out.
3. Disconnect the wiring harness from the back of the top grille. 
4. Lay the top grille on a soft surface.
Model
Reduced Tipping Radius
36
42 
48
88" (223.5 cm)
88
¹⁄₂" (224.8 cm)
89
¹⁄₄" (226.7 cm)
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not 
completely installed. 
Keep doors taped closed until refrigerator is 
completely installed.
Use two or more people to move and install 
refrigerator.
Failure do so can result in death or serious injury.
A. Top grille
B. Cabinet side trim
A. Top grille
B. Cabinet side trim
C. Louver panel
B
B
A
A
B
B
C