Simrad AP26 Manual De Usuario

Simrad AP26 and AP27 Autopilots 

44

 

20221586B

 

 

 

DisLog 
Select the Log source. 
 
Depth 
Select the source for depth data. 

Course Adjust 

 

When using the   (PORT) or   (STBD) buttons in 
AUTO mode, you are changing the set course in 1° 
increments. If you prefer the increments to be 10° 
each press (does not apply for sailboats), proceed as 
follows: 

Select  Course adjust and turn the course knob to change the 
setting. The default value is 1°, which is the preferred setting. 
Select 10° if you want to make major course changes in 10° 
increments with the buttons and fine-tune the set course with the 
course knob. 
Press the STBY button to leave the User setup. 

Settings that are added for the AUTO and WIND modes are 
shown below. Other relevant settings are described under 
STANDBY mode in this chapter. 

 

Seastate filter 
OFF: 

Seastate filter is disabled. 

AUTO: 

Automatically reduces rudder activity 
and autopilot sensitivity in rough 
weather by an adaptive process (default).

MANUAL: Manual yaw band adjust (1-10, 10 

≈ 

±6°). 

The manual setting determines the number of degrees the vessel 
may deviate from the set course before any command is given to 
the rudder. The AUTO setting is recommended. The MANUAL 
settings may be used to find the optimum combination of course 
keeping and low rudder activity in rough but steady sea 
conditions.