Simrad AP26 Manual De Usuario

Installation 

20221586B

 63 

•  Locate the cradle on the mounting site and mark the 4 holes 

for the fixing screws on the mounting surface.  

•  Drill the 4 mounting holes and screw the cradle to the 

mounting surface. 

•  Use the supplied screws to fasten the control unit to the left 

and right brackets. 

•  Apply the front panel corners. 
•  Use the two locking knobs to assemble the cradle with the left 

and right brackets and adjust the control head to best viewing 
angle. 

•  Connect the Robnet2 cable(s) to the control unit connector(s) 

(See note on page 64). 

 

As Robnet2 units have two Robnet2 connectors (blue) they can 
be used as "jack points" for further expansion of the system. 
There are no dedicated "in" or "out" connectors. You may 
connect the cables to any available Robnet2 connector (blue) on 
the specific unit. The Robnet2 connectors have a locking 
mechanism for extra safety. 

The 15 m cable to the autopilot computer has a connector only at 
the control unit end. Robnet2 cables with 5 pin male connector at