Manualsbrain.com
  1. Manuales
  2. Marcas
  3. GTO
  4. GP-SW050
  5. Manual De Usuario

GTO GP-SW050 Manual De Usuario

Descargar
Página de 37
18
stall Force and auto-close adjustments
Stall Force Adjustment: 
IMPORTANT:   For safety reasons, the
 STALL FORCE
 potentiometers are set at the “10 o’clock” position
at the factory. 
The obstruction sensitivity is independently adjustable for each direction of travel. Upon sensing an 
obstruction, the gate will stop and reverse direction for approximately 2 seconds.
1.  Turning the potentiometer clockwise (toward the MAX position) increases the amount of force
the operator applies to an obstruction. Turning the potentiometer counter-clockwise (toward the
MIN position) decreases the amount of force the operator applies to an obstruction.
2.  Use a small screwdriver to adjust the appropriate potentiometer and operate the gate until it can
run without obstructing and reversing direction.
1
   2
   3
   4
O
N
CYCLE
SAFETY
SHADOW
OPEN
CLOSE
STOP
OPEN
EDGE
CLOSE
EDGE
STALL  FORCE  ADJUST
LIMIT ADJUSTMENTS
DIAG.
 PORT
RUNNING
OPTIONS
MIN
MAX
MIN
MAX
OFF
120
<<<       JOG      >>>
<<<                         >>>
SET
LIMIT
CLOSED
LED10
LED09
AUTO   CLOSE
TIMER
MODE  1
MODE  2
OPEN DIR.
SLV OPN
DUAL MODE
LOW BATT
ON
ON
>>>
SIMUL
SLAVE
SECURE
OFF
OFF
<<<
DELAY
MASTER
SAFE
CYCLE
SAFETY
OPEN EDGE
RUN 2
OPEN
CLOSE
STOP
COM
COM
COM
SHADOW
LOOP
REL
AY OUTPUT
S
LOCK N.C.
LOCK COM
LOCK N.O.
RUN 1
RUN 2
CLOSED 1
CLOSED 2
1
   2
   3
   4
O
N
CYCLE
SAFETY
SHADOW
OPEN
CLOSE
STOP
OPEN
EDGE
CLOSE
EDGE
STALL  FORCE  ADJUST
LIMIT ADJUSTMENTS
DIAG.
 PORT
RUNNING
MIN
MAX
MIN
MAX
OFF
120
<<<       JOG      >>>
<<<                         >>>
SET
LIMIT
CLOSED
LED10
LED09
SAFETY
SHADOW
OPEN
EDGE
CLOSE
EDGE
OPEN
CLOSE
STOP
C
O
M
AUTO   CLOSE
TIMER
Auto-Close Adjustment: 
The Auto-Close potentiometer allows the user to set the time that the gate will stay at the open
position/limit before it automatically starts to close the gate.
This feature can be turned off by turning the 
AUTO CLOSE TIMER
 potentiometer all the way
counter- clockwise. It is shipped from the factory in the OFF position (auto close feature is disabled).
•  The auto close time is adjustable from 3-120 seconds.
•  This feature is only enabled when the gate is at the open limit.
•  This feature is disabled if the following inputs are activated.
•  OPEN, SAFETY, SHADOW, CLS-EDGE or STOP.