Mitsubishi wd-52527 Manual De Propietario

Note: If you selected “Other” for any of the 
device names, you can direct the TV to “Learn” 
the connected device by following the Edit 
NetCommand instructions.   For many device types, 
non-listed models will operate in the same way as 
the listed models and you can still use the pre-
loaded setting.

If the devices connected to the TV are already in 
NetCommand memory, you can quickly select them at 
this screen.  Press ADJUST   or   to move to each 
device type.  Press ADJUST 

 or   to select the 

manufacturer.    Select  “Other”  if  the manufacturer is 
not listed.  Later, you can use the Change setting in the 
Edit NetCommand  menu to learn the remote control 
signals for this device.  Select “None” for device types 
that are not connected. 

For the A/V Receiver, if the manufacturer is not 
listed, you cannot select “Other”.  Instead, select 

“None”.  Later, you can use the “Add” feature in the 

NetCommand menu to have the TV add and learn the 
remote control signals for this device.   

If you have a camcorder connected, check the 
Camcorder box.  NetCommand will not be able to 
control it, but will reserve the front input to use with 
the camcorder.  After completing your choices, select 
Next> and press ENTER.

The TV Guide On Screen option allows you to select 

whether you want to enable the TV Guide On Screen 
system and, if so, which devices you want to include.  In 
order to get the correct listings for your area, you will 
need to enter your five-digit ZIP code.

You can select one over-the-air source and one cable 

source for TV Guide On Screen.  If, however, you have 
multiple cable sources, the channel-number assignments 
may not match up correctly.  See the table below for the 
preferred connection combinations.

Ant-1 over-the-air 

reception

•  Cable box (on any input)
•  Ant-2 channels memorized 

via cable

Ant-2 over-the-air 

reception

•  Cable box (on any input)
•  CableCARD™ on Ant-1
•  Ant-1 channels memorized 

via cable

For detailed information on using the TV Guide On 
Screen system, please see the separate TV Guide On 
Screen Interactive Program Guide User’s Manual.

•  Inputs to TV Guide On Screen can include:

- 

Only one over-the-air source

- 

Only one cable source

•  If your cable box is connected using HDMI or 

IEEE-1394, we recommend you also connect an 
antenna.

•  If your cable box is connected to Component 1 or 2, 

you should make sure the box is set to send analog 
channels as 480i.  If this is not possible, add an 
antenna.