Mitsubishi wd-52527 Manual De Propietario

After you have made your device choices the Review 

Screen will display.  It is important to review the settings 
to ensure that they are correct.  If necessary, you can 
use 

<Back to return to the Device Setup screen to make 

changes.  

To complete the NetCommand setup, select 

Finish 

from the Finish screen. 

If you wish to change any of the pre- configured 
inputs or names for the devices, or add devices not in 
the pre-configured setup, select 

Edit to display Edit 

NetCommand menu.

If your A/V receiver was not listed, select 

Edit to add 

the AVR and then assign all devices to new AVR inputs.  

It is still necessary to memorize the available channels 
for Antenna-1 (and Antenna-2, if used).  You may do 
that by going to the TV Main menu and selecting 

Antenna.  Instructions to memorize channels are found 

in the Antenna menu section.  

Note:  The Review screen lists the TV input and A/V 
receiver input used with each device.  You must 
correctly identify the inputs you used when you 
connected the devices.  If you have not connected 
your devices, write down these inputs as a guide.  If 
you cannot use these inputs, or if you would like to 
change the name of a device, use the instructions in 
Edit NetCommand to make necessary changes.

Note: If you select Next> on the Review screen, all 
selections made are finalized.

On the Review screen, adding or deleting check marks 
will turn the adjacent devices or inputs On or Off.  1394 
device names only appear on the Review screen when 
the devices are connected to the TV.