Mitsubishi wd-52527 Manual De Propietario
Chapter 3. NetCommand Setup and Editing
Edit NetCommand
®
, Add an A/V Receiver, continued
A/V Receiver (AVR) Learn Screen
Figure 10
1. Press ADJUST or on the TV remote to select the
check box for
each function to be learned.
2. Press ENTER and the function name will begin to flash
to confirm the ready-to-learn status.
3. Press the button on the A/V receiver’s remote control
that corresponds to the selected function, A check
mark will appear and the function name will stop
flashing. This confirms the signal learned status.
mark will appear and the function name will stop
flashing. This confirms the signal learned status.
4. To test the learned command, press ENTER on the TV
remote. The A/V receiver will perform the selected
function. The A/V receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 31 for IR emitter placement).
function. The A/V receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 31 for IR emitter placement).
5. Repeat for each function to be learned.
6. To erase a learned function, highlight the check box for
that function and press CANCEL.
7. When the function signals have been learned, press
ADJUST to select
Next> and move to the Name
screen.
A/V Receiver (AVR) Input Learn Screen
Figure 9
NetCommand can now learn the remote control signals
used to select each input on the A/V receiver.
used to select each input on the A/V receiver.
1. Press ADJUST or on the TV remote to select the
check box for
each function to be learned.
2. Press ENTER and the function name will begin to flash
to confirm the ready-to-learn status.
3. Press the button on the A/V receiver’s remote control
that corresponds to the selected function. A check
mark will appear and the function name will stop
flashing. This confirms the signal learned status.
mark will appear and the function name will stop
flashing. This confirms the signal learned status.
4. To test the learned command, press ENTER on the TV
remote. The A/V receiver will perform the selected
function. The A/V receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 31 for IR emitter placement).
function. The A/V receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 31 for IR emitter placement).
5. To customize the input names, press ADJUST to
move to the Input Name text box and then press
ADJUST or and ENTER to select each letter of the
name. These names will appear on the Review screen
as the A/V receiver’s input names, and should match
the names the A/V receiver shows in its own display.
ADJUST or and ENTER to select each letter of the
name. These names will appear on the Review screen
as the A/V receiver’s input names, and should match
the names the A/V receiver shows in its own display.
6. To erase the learned input signal, highlight the check
box for that input and press CANCEL.
7. Repeat for each connected input.
8. When the input selection signals have been learned
and the inputs named, press ADJUST to select
Next> and move to the A/V receiver Learn screen.
Next> and move to the A/V receiver Learn screen.
Figure 9. A/V receiver Input Learn screen
Figure 10. A/V receiver Learn screen
IMPORTANT
When learning remote control signals, point
the device’s remote at the TV screen