GE zem200bf Instruccion De Instalación

Installation Preparation

Note: When installed, trim

kit will require wall space

26-1/8" W x 16-1/4" H for

clearance.

Within opening of appropriate dimensions:
• Install a level base of plywood:

– Flush with lower edge of opening.
– Entirely covering floor of opening.

• 3/8" thick (min.) plywood must be sup-

ported by 2" x 4" or 1" x 2" equivalent
runners on all sides.

• Finished floor must support a minimum of

100 pounds.

• JX827 accessory kit may be assembled and

installed at this time. Refer to “Installation”
for instructions.

The JX827 accessory kit provides trim strips to
conceal all raw edges of cabinets.

• 3/8" thick plywood (min.)

• 2" x 4" lumber

• Saw

• Screws and screwdriver or other hardware for construction of

plywood base.

The opening must be:
• 24-7/8" 

±

 1/16" wide.

• 15" 

±

 1/16" high.

• With approximately 1-1/4" for oven trim

overlap around all edges of opening.

• Deep enough to accommodate electrical

receptacle and permit adequate air circula-
tion for proper venting:
– Minimum 18" deep with receptacle inside

cutout.

– Minimum 16" deep with receptacle outside

cutout.

• Height from floor may vary according to

preference of user.

18" Min.
Receptacle
Inside
16" Min.
Receptacle
Outside

15" 

±

 1/16

24-7/8"

±

1/16"

16"-18" Min.

15"

±

1/16"

3/8"
Plywood
Base

2 x 4 or 1 x 2
Equivalent runners
must support base
of all 4 sides

Opening

Cabinet

4