Bakers Pride 101 Manual De Usuario
Figure “C”
Al g
en
i nm
t
A. CLEANING INSTRUCTIONS
!
Clean the unit regularly after use.
!
Top Grates: after removing from the unit, use warm soapy water and a stiff bristled brush or plastic pad.
Cooking grates must be removed to steam clean or pressure wash. Do not use steel wool or abrasive pads as
they may degrade the metal finish. Always clean stainless steel panels along the grain.
Cooking grates must be removed to steam clean or pressure wash. Do not use steel wool or abrasive pads as
they may degrade the metal finish. Always clean stainless steel panels along the grain.
!
Radiants/Covers: These will need little or no cleaning due to high in-use temperatures. If necessary clean as
top grates.
top grates.
!
Broiler body: Use warm, soapy water and a stiff bristle brush or plastic pad. Do not use chlorine, bleach or
other caustic chemicals. Be careful not to get water into the burners or carryover tubes. Do not pressure wash.
other caustic chemicals. Be careful not to get water into the burners or carryover tubes. Do not pressure wash.
!
Water Pans/Stand: Clean like top grates.
B. BURNER / ORIFICE INSPECTION
1.
Remove the front shelf by removing the two screws at the ends.
2.
Slide front shelf forward and then lift it off the unit.
3.
The front of the burners, the valve bodies, and orifices are now exposed for inspection. Looking down into the
unit, compare each assembly with figure “C” for alignment.
unit, compare each assembly with figure “C” for alignment.
4.
If the components are not aligned as shown in the diagram, discontinue use and contact the appliance
manufacturer.
manufacturer.
5.
If the components are aligned, carefully replace the service shelf and re-insert and tighten the screws. Your
unit is ready for use.
unit is ready for use.
Figure “B”
Lighter Hole Burner Knob Crossover Tube Knob
NOTE: If the tank valves are not opened very slowly, an excess flow valve in the tank connector fitting (a safety
feature) may restrict the flow of gas to the unit resulting in little or no flame at the burners. Should this happen, follow
the shutdown instructions and be sure to shut off tanks and remove and re-attach the tank connectors as instructed.
This is necessary to re-set a closed excess flow valve. Repeat all steps of the lighting instructions. The appliance
should now function normally.
feature) may restrict the flow of gas to the unit resulting in little or no flame at the burners. Should this happen, follow
the shutdown instructions and be sure to shut off tanks and remove and re-attach the tank connectors as instructed.
This is necessary to re-set a closed excess flow valve. Repeat all steps of the lighting instructions. The appliance
should now function normally.
B. SHUTDOWN INSTRUCTIONS
To shut down the unit, turn all burners and carryover tube knobs clockwise to the OFF position. Close gas tank
valve(s), disconnect propane tank(s) and leave them outdoors.
valve(s), disconnect propane tank(s) and leave them outdoors.
3. MAINTENANCE INSTRUCTIONS
6