KitchenAid 30-Inch 4 Element Induction Cooktop, Architect® Series II Guía De Instalación

■

If the house has aluminum wiring, follow the procedure 
below:

1. Connect a section of solid copper wire to the pigtail 

leads.

2. Connect the aluminum wiring to the added section of 

copper wire using special connectors and/or tools 
designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended 
procedure. Aluminum/copper connection must conform with 
local codes and industry accepted wiring practices.

1. Decide on the final location for the cooktop.

NOTE: Countertop must be 1

³⁄₁₆" (3.0 cm) to 2" (5.1 cm) thick.

2. If necessary, make cutout in countertop before installing 

cooktop. See “Location Requirements” section for more 
information.

3. Clean cutout of any remaining dust and debris.

NOTE: Kit Part Number W10310006 is required for installing the 
cooktop into a solid surface or marble countertop. See the 
“Assistance or Service” section of the Use and Care Guide for 
information on ordering.

1. Clean the brackets and cooktop cutout of any dust and 

debris.

2. Measure the center line of the vertical sides of the cooktop 

cutout.

3. Apply the adhesive provided in the kit to the back side of the 

brackets.

4. Position brackets in the center of the vertical centerline and 

align the upper edge of the brackets so that they are flush 
with the countertop.  

5. Push the brackets firmly onto each side of the cooktop cutout 

and wait 1 hour for adhesive to dry.

1. Measure the center line of the vertical sides of the cooktop 

cutout.

2. Position brackets in the center of the vertical centerline and 

align the upper edge of the brackets so that they are flush 
with the countertop.

3. Attach the brackets in the cutout with the screws provided.

Center line

Center line

A

B