KitchenAid 36-Inch 5 Burner Gas Cooktop, Architect® Series II Guía De Instalación

Descargar
Página de 24
8
Installing Brackets Before Placing Cooktop in Cutout
1. Using 2 or more people, place the cooktop upside down on a 
covered surface.
2. Remove the attachment screws for the selected bracket 
locations from the bottom of the cooktop base. 
3. Select bracket mounting holes that will allow the bracket to 
extend far enough out from the cooktop for the installation of 
2½" (6.4 cm) clamping screws. See “Attach Cooktop to 
Countertop” for illustration of clamping screw installation. 
4. Attach brackets to cooktop base bottom with bracket 
attachment screws using the bracket mounting holes 
selected in Step 2.
5. Rotate brackets so they do not extend beyond edge of 
cooktop base.
6. Tighten screws just enough to hold brackets in place when 
cooktop is put in cutout.
7. Using 2 or more people, turn the cooktop right side up and 
place in cutout.
NOTE: Make sure that the front edge of the cooktop is 
parallel to the front edge of the countertop. If repositioning is 
needed, lift entire cooktop up from cutout to avoid scratching 
the countertop.
8. Loosen the screws and rotate the brackets so that they are 
perpendicular to the edge of the cooktop base and extend 
beyond its edge. Securely tighten screws.
Installing Brackets After Placing Cooktop in Cutout
1. Using 2 or more people, place cooktop right side up into the 
cutout.
NOTE: Make sure that the front edge of the cooktop is 
parallel to the front edge of the countertop. If repositioning is 
needed, lift entire cooktop up from cutout to avoid scratching 
the countertop.
2. Remove the attachment screws for the selected bracket 
locations from the bottom of the cooktop base. 
3. Select bracket mounting holes that will allow the bracket to 
extend far enough out from the cooktop for the installation of 
2½" (6.4 cm) clamping screws.
4. Attach brackets to cooktop base bottom with bracket 
attachment screws using the bracket mounting holes 
selected in Step 3. Securely tighten screws.
Make Gas Connection
To Assemble Pressure Regulator:
1. Using 2 or more people, stand the cooktop on its side or 
back.
A. Edge of cooktop base bottom
B. Clamping bracket
A
B
A. Cooktop
B. Cooktop base
C. Attachment screw
D. Clamping bracket (extends far enough beyond 
cooktop base to allow installation of clamping 
screws)
E. 2½" (6.4 cm) clamping screw (to be installed in 
“Attach Cooktop to Countertop”)
F. Countertop
A
B
C
D
E
F
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure 
gas pressure does not exceed 14" (36 cm) water 
column. 
Examples of a qualified person include: 
licensed heating personnel, 
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.