Cisco Cisco Firepower Management Center 2000 Guía De Instalación
Restoring a Firepower Management Center to Factory Defaults
Firepower Management Center Getting Started Guide
12
sudo /usr/local/sf/bin/configure_console.sh vga
—
To access the appliance using the physical serial port:
sudo /usr/local/sf/bin/configure_console.sh serial
—
To access the appliance using LOM via SOL:
sudo /usr/local/sf/bin/configure_console.sh sol
3.
To implement your changes, reboot the appliance by typing
sudo
reboot
.
The appliance reboots.
Using the Web Interface to Redirect the Console Output
Procedure
1.
Select
System > Configuration.
2.
Select
Console Configuration.
3.
Select a remote console access option:
—
Select
VGA
to use the appliance's VGA port. This is the default option.
—
Select
Physical Serial Port
to use the appliance's serial port, or to use LOM/SOL on a Management Center.
If you selected
Physical Serial Port
, the LOM settings appear.
4.
To configure LOM via SOL, enter the appropriate settings:
—
DHCP Configuration
for the appliance (
DHCP
or
Static
).
—
IP Address
to be used for LOM. The LOM IP address must be different from the management interface IP
address of the appliance.
—
Netmask
for the appliance.
—
Default Gateway
for the appliance.
5.
Click
Save
.
Remote console configuration for the appliance is saved. If you configured Lights-Out Management, you must
enable it for at least one user; see
enable it for at least one user; see
Restoring a Firepower Management Center to Factory
Defaults
Defaults
Cisco provides ISO images on its Support Site for restoring, or reimaging, Firepower Management Centers to their
original factory settings.
original factory settings.
For more information, see the following sections: